Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
enable
disable
<channel-name>
deny
permit
preview
query
start
pause
resume
remove
This example describes how to configure an IPTV rule to permit
access to Channel 1.
ZXR10(config)#interface gei_2/1
ZXR10(config-gei_2/1)#iptv vlan 1 service start
ZXR10(config-gei_2/1)# iptv vlan 1 control-mode channel
ZXR10(config-gei_2/1)#iptv vlan 1 channel id-list 1 den
ZXR10(config-gei_2/1)# iptv vlan 1 max-access 10
show iptv rule
show iptv rule statistics
jumbo-frame
Use this command to set whether the Ethernet port shall support
jumbo frames. Restore the default with the no command.
Interface configuration
jumbo-frame {enable | disable}
no jumbo-frame
enable
disable
Jumbo frames are not supported.
This example describes how to set port gei_2/1 not to support
jumbo frames.
ZXR10(config)#interface gei_2/1
ZXR10(config-if)#jumbo-frame disable
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Enabling CDR function
Disabling CDR function
Channel name
Denying channel accesses
Permitting channel accesses
Previewing a channel
Querying a channel
Starting IPTV service
Pausing IPTV service
Resuming IPTV service
Removing IPTV service
Enables the Ethernet port to support jumbo
frames
Disables the Ethernet port to support jumbo
frames
33