Advertisement
*Images may differ from actual products.
Measure the temperature and humidity of the environment and send you instant notifications when the environment changes. It is suitable for green houses, bedrooms, nursery, incubators, and wine cellars.
A Tapo Hub is required. Make sure your Tapo Hub is successfully added via the Tapo app.
Remove the battery insulation tab to power up your sensor. The LED should blink.
Note: If the LED is not blinking, use a pin to press the Reset button for 5 seconds to reset your sensor and enter pairing mode.
Open the Tapo app and tap the button. Select Sensors and then your model. Follow the app instructions to complete setup.
Take your sensor to the preferred location.
Single press the Reset button. Your hub should make a voice prompt.
Blow on the sensor detector. The temperature and humidity displayed on the Tapo app should change.
(The installation height should not be higher than 2 meters.)
Visit www.tapo.com/support/ for technical support, user guides, FAQs, warranty & more
This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
Risk of explosion if the battery is replaced by an incorrect type.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download TP-Link Tapo T310 - Smart Temperature and Humidity Sensor Quick Start Guide
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Tapo T310 that isn't answered in the manual? Leave your question here.