Summary of Contents for Seagate EXOS ENTERPRISE 7E2000 SATA
Page 1
7E2000 SATA Product Manual Standard Self-Encrypting models models ST2000NX0243 ST2000NX0283 4096 Native ST1000NX0303 ST1000NX0343 ST2000NX0253 ST2000NX0303 Emulation ST1000NX0313 ST1000NX0353 ST2000NX0403 Native ST1000NX0423 100827452, Rev. B November 2017...
Page 2
Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Raid Rebuild and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a certification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.All other trademarks or registered trademarks are the property of their respective owners.
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/recover/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Seagate recommends validating the configuration with the selected HBA/RAID Note controller manufacturer to ensure use of full capacity is supported. Previous generations of Seagate Self-Encrypting Drive models were called Full Disk Encryption (FDE) models before a differentiation between drive-based encryption and Note...
Shadow Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification. The specification can be downloaded from www.serialata.org. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Startup current 2.0A (typical) 12V (peak) 1.85A (optional configuration through Smart Command Transport) Voltage tolerance 5V ±5% (including noise) 12V ±5% 5° to 55°C (operating/tested) Ambient temperature –40° to 70°C (nonoperating) Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 10
*One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. **During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
0.22 5.09 Maximum (peak) DC 0.60 0.33 *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 13
0.17 4.49 Maximum (peak) DC 0.60 0.30 *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 14
2.5.1.1 Typical current profiles Figure 1. 2TB Typical 12V & 5V startup and operation current profile Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 15
2.5.1.2 Typical current profiles Figure 2. 1TB Typical 12V & 5V startup and operation current profile Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disk access is necessary. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
• Saved enabled state, and timer value • Current enabled state, and timer value S.M.A.R.T. Read Data Reports • Attribute 192 - Emergency Retract Count • Attribute 193 - Load/Unload Cycle Count Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 18
Disable EPC Feature Set PowerChoice Supported Extended Power Condition Identifiers Power Condition Identifiers Power Condition Name Standby_z 01 - 80 Reserved Idle_a Idle_b Idle_c 84 - FE Reserved All EPC Power Conditions Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Non-operating –40° to 158°F (–40° to 70°C) package ambient with a maximum gradient of 36°F (20°C) per hour. This specification assumes that the drive is packaged in the shipping container designed by Seagate for use with drive. HDA Temp.
All models 3.0 bels (max) 3.4 bels (max) *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Test for Prominent Discrete Tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
From this page, click on the “Is my Drive under Warranty” link. The following are required to be provided: the drive serial number, model number (or part number) and country of purchase.The system will display the warranty information for the drive. Preventive maintenance None required. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Seagate drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with all relevant regulatory requirements and standards for the drives, Seagate cannot guarantee that all system-level products into which the drives are installed comply with all regulatory requirements and standards applicable to the system-level products. The drive is designed for operation inside a properly designed system (e.g., enclosure designed for the drive), with properly shielded I/O cable (if...
2.11.6 Morocco Commodity Mark To satisfy our OEM customers, Seagate has added the Moroccan Commodity Mark to the drives provided to the OEM for the sale of Customer Kits produced by our OEM customers that are intended to be incorporated into the OEM's finished system-level product by an end user.
2.12.2 Restriction of Hazardous Substances in Electrical and Electronic Equipment Seagate drives are designed to be compliant with the European Union RoHS "Recast" Directive 2011/65/EU (RoHS 2) as amended by Directive (EU) 2015/863. The RoHS2 restricts the use of certain hazardous substances such as Lead, Cadmium, Mercury, Hexavalent Chromium, Polybrominated Biphenyls (PBB) and Polybrominated Diphenyl Ether (PBDE), BisBis(2-Ethylhexyl) phthalate (DEHP), Benzyl butyl phthalate (BBP), Dibutyl phthalate (DBP), and Diisobutyl phthalate (DIBP) in electrical and electronic equipment (EEE).
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
Seagate’s option and at no charge to the customer, if returned by customer at customer’s expense to Seagate’s designated facility in accordance with Seagate’s warranty procedure.
Figure 4. Attaching SATA cabling Image is for reference only, may not represent actual drive Note Each cable is keyed to ensure correct orientation. Exos 7E2000 SATA drives support latching SATA connectors. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
• Do not cover breather hole on top cover. Breather Hole Do Not Cover Figure 5. Breather hole location - top cover Image is for reference only, may not represent actual drive Note Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
0.437 lb 1TB models 190 g 0.419 lb These dimensions conform to the Small Form Factor Standard documented in Note SFF-8201 and SFF-8223, found at www.sffcommittee.org. Figure 6. Mounting configuration dimensions Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate’s SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two ATA commands: •...
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: The download must be an SED file.
The drive shall not support the OVERWRITE EXT and BLOCK ERASE EXT sub-commands. Support of the SANITIZE FREEZE LOCK EXT command shall be determined on a customer-specific basis. OEM drives shall support the command. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
12V power, pre-charge, 2nd mate 12V power 12V power * Pins P1, P2 and P3 are tied together. † Host commanded disable via pin P3 is NOT supported by Exos 7E2000 Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Drives with capacities over 137GB will have 0FFFFFFFh in this field and the actual number of user-addressable LBAs specified in words 100-103. This is required for drives that support the 48-bit addressing feature. Retired 0000 Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 38
The mandatory value of the world wide name (WWN) for the drive. Each drive will have a unique NOTE: This field is valid if word 84, bit 8 is set to 1 indicating 64-bit WWN support. value. 112–118 ATA-reserved 0000 Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 39
Shall be cleared to 0. Word 88 Ultra DMA mode 0 is supported. Ultra DMA mode 1 is supported. Ultra DMA mode 2 is supported. Ultra DMA mode 3 is supported. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above. Note Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Exos 7E2000 v3 SATA Product Manual, Rev. B...
Page 42
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100827452, Rev. B...