Gpu Card Installation Guidelines; Removing A Expansion Card - Dell EMC PowerEdge T440 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge T440:
- Installation and service manual (115 pages) ,
- Simple operation manual (9 pages) ,
- Manual (150 pages)
Table of Contents
Advertisement
GPU card installation guidelines
Observe the following guidelines while installing a GPU card:
•
GPU are supported only in the Rack mode configuration.
•
GPU can be installed only on systems that have 1100 W or higher power supply units.
•
Each GPU card supports up to 32 GB of dedicated GDDR5 memory.
•
Two double-width GPU cards on a single processor configuration and four double width GPU cards on a dual processor configuration
do not support any other add-on cards.
•
The GPU cards must be installed:
•
On GPU enabled system (two processor and also contains the main air shroud and GPU air shrouds).
•
Specific GPU cards will need the use of the dongle power cable.
GPU card installation restrictions
•
Supports only single slot GPU card.
•
Supports only active (embedded fan) GPU card.
•
High power (>75W) GPU cards that use GPU AUX cable should have dual system fans without redundancy.
Removing a expansion card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air shroud.
4
Remove the expansion card holder.
Steps
1
If installed, disconnect the data cables from the PERC card and/or the power cables from the GPU card.
2
Press the expansion card latch and push down the latch to open it.
3
Hold the expansion card by its edge, and pull the card up to remove it from the expansion card connector and the system.
4
Install the filler brackets by performing the following steps:
a
Align the slot on the filler bracket with the tab on the expansion card slot.
b Press the expansion card latch till the filler bracket locks into place.
NOTE:
Filler brackets must be installed in empty expansion-card slots to maintain FCC certification of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
116
Dell EMC PowerEdge T440 Installation and Service Manual
Installing and removing system components
Safety
instructions.
Before working inside your
system.
- Quick Links:
- Status Led Indicators
- Status Led Indicators
Hide quick links:
Advertisement
Table of Contents
