NZXT - H7 Flow ATX Mid-Tower Case - White

I got this case as Open Box, and it was like new. The Fans were loosely mounted, but that was all that indicated this case was being unpacked before. Thx to BB for this, a really good purchase. The only gripe I have is a slightly bent front mesh bracket, the is pretty flimsy and not mounted totally flat. Now to the case itself: It is pretty roomy, allowing for two radiators to be mounted simultaneously. Coming from a Lancool II I really appreciate the extra room in the top, enabling me to put my H115i 280mm rad in without the mainboard's VRM heatsinks getting in the way. In the front, I've mounted the 360mm rad of my GPU in a push/pull config (only for the looks, push OR pull alone would have been enough cooling-wise). With the 25mm rad mounted on the outside, it allows to have 25mm fans on the outside as well without the blades touching the mesh - IF the mesh bracket isn't bent, that is (unfortunately mine is, I've helped it with using other screws and washers for the lower fan to push the mesh out slightly). For the GPU I'm re-using my Lian-Li mount that I got for the Lancool II. It does fit when making sure the mainboard is mounted as far away from the back of the case as possible as the bracket is quite thick. Also, I had to leave out the movable part that goes onto the bracket depending on where it is mounted. To give it a bit more stability and prevent sag over time I'm resting the bracket on a fan that is mounted on top of the PSU shroud. This bottom fan is a mod that I created as I was missing some airflow around the chipset, the VRMs, and the backplate of my GPU (which has additional thermal pads so it actually does help with cooling). Since the shroud's hole pattern doesn't match the spacing of a 120mm fan's mounting holes I had to develop an adapter to put a fan there. After printing it I just had to screw it to the fan and then "plug" it onto the shroud. It uses a reverse fan that looks good even though it blows air upwards. The air it gets comes from the front, the PSU is not part of the overall case airflow as its fan is facing down. I really love the looks of the case, and that it makes it easy to build in it. Cable management is great, air flow as well, and the build quality appears to be top-notch, too (well, except for that flimsy front mesh bracket).

Looks great, lots of space for all the parts. Airflow is fantastic and it makes cable management a breeze

Wonderful case. Very easy to work in and looks great when its completed. Airflow is terrific and the size is excellent for the ever growing pgu sizes! I wish they included 3 fans or 0-1 fans. 2 makes it odd to configure fan set up if you are trying to make it look cohesive. I ended up removing both of them and purchasing some other fans. The ease of removing the panels is nice just be careful with the glass. Clean, simple and great airflow!