Abstract
The thiosulfate method is a cyanide-free hydrometallurgical method for gold extraction, but the existence of copper ion in Cu2+–NH3–S2O32− system is not conducive to the subsequent gold(I) recovery. This paper describes a process for improving the gold(I) adsorption capacity of mercapto-functionalized silica gel (MP-SG) by using ethylenediamine (en) as an additive to mask copper(II). The effects of en/Cu2+ molar ratio, contact time, and pH on adsorption were investigated. The results showed that the addition of en increased the adsorption capacity of MP-SG to gold by more than 70%. X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) confirmed that the valence states of gold and copper on the adsorbent were both + 1, which confirmed the occurrence of competitive copper(II) adsorption. This could be inhibited by the addition of en without affecting the interfacial properties of MP-SG. UV–vis spectroscopy and the distribution of copper species revealed that addition of en changed the composition of the solution, forming a more stable Cu(en)22+ complex, the fraction of Cu(en)22+ increased with en content, thus reducing the competitive adsorption of Cu(II) to gold (I). The recovery rate of gold in the actual thiosulfate leaching solution was up to 92.35%, and en has almost no influence on the recycling process of the recovered leaching liquor, which proves the feasibility of this method in practical application.
Similar content being viewed by others
Data availability
Raw data for X-ray diffraction spectroscopy (XRD), X-ray photoelectron spectroscopy (XPS) and UV-vis spectroscopy supporting the results of this study are available in its supplementary information file. Should any raw data files be needed in another format they are available from the corresponding author upon reasonable request.
References
Ahtiainen R, Lundström M, Liipo J (2018) Preg-robbing verification and prevention in gold chloride-bromide leaching. Miner Eng 128:153–159. https://doi.org/10.1016/j.mineng.2018.08.037
Alsaman AS, Askalany AA, Ibrahim EMM, Farid AM, Ali ES, Ahmed MS (2022) Characterization and cost analysis of a modified silica gel-based adsorption desalination application. J Clean Prod 379:134614. https://doi.org/10.1016/j.jclepro.2022.134614
Azizitorghabeh A, Mahandra H, Ramsay J, Ghahreman A (2021) Gold leaching from an oxide ore using thiocyanate as a lixiviant: process optimization and kinetics. ACS Omega 6:17183–17193. https://doi.org/10.1021/acsomega.1c00525
Battistoni CMG, Cariati F et al (1977) XPS photoelectron spectra of cluster compounds of gold. Inorg Chim Acta 24:207–210. https://doi.org/10.1016/s0020-1693(00)93875-1
Betancur JC, Montoya PM, Calderón JA (2019) Gold recovery from ammonia-thiosulfate leaching solution assisted by PEI-functionalized magnetite nanoparticles. Hydrometallurgy 189:105–128. https://doi.org/10.1016/j.hydromet.2019.105128
Chen S, Zi F, Hu X, Chen Y, Yang P, Wang Q, Qin X, Cheng H, Liu Y, He Y, Wang C, Hu D, Liu Y, Zhang Y (2020) Interfacial properties of mercaptopropyl-functionalised silica gel and its adsorption performance in the recovery of gold(I) thiosulfate complex. Chem Eng J 393:124547. https://doi.org/10.1016/j.cej.2020.124547
Choi N-C, Kim B-J, Cho K, Lee S, Park C-Y (2017) Microwave pretreatment for thiourea leaching for gold concentrate. Metals 7:404. https://doi.org/10.3390/met7100404
Choi JW, Song MH, Bediako JK, Yun YS (2020) Sequential recovery of gold and copper from bioleached wastewater using ion exchange resins. Environ Pollut 266:115167. https://doi.org/10.1016/j.envpol.2020.115167
Choo WL, Jeffrey MI (2004) An electrochemical study of copper cementation of gold(I) thiosulfate. Hydrometallurgy 71:351–362. https://doi.org/10.1016/s0304-386x(03)00087-2
Deroubaix GMP (1992) X-ray photoelectron spectroscopy analysis of copper and zinc oxides and sulphides. Surf Interface Anal 18:39–46. https://doi.org/10.1002/sia.740180107
Descostes MMF, Thromat N et al (2000) Use of XPS in the determination of chemical environment and oxidation state of iron and sulfur samples: constitution of a data basis in binding energies for Fe and S reference compounds and applications to the evidence of surface species of an oxidized pyrite in a carbonate medium. Appl Surf Sci 165:288–302. https://doi.org/10.1016/s0169-4332(00)00443-8
Dong Z, Jiang T, Xu B, Yang Y, Li Q (2017) Recovery of gold from pregnant thiosulfate solutions by the resin adsorption technique. Metals 7:555. https://doi.org/10.3390/met7120555
Dong Z, Jiang T, Xu B, Yang Y, Li Q (2019) An eco-friendly and efficient process of low potential thiosulfate leaching-resin adsorption recovery for extracting gold from a roasted gold concentrate. J Clean Prod 229:387–398. https://doi.org/10.1016/j.jclepro.2019.05.033
Ilankoon ND, Aldrich C, Oraby EA, Eksteen JJ (2019) Extraction of gold and copper from a gold ore thiosulfate leachate by use of functionalized magnetic nanoparticles. Miner Process Extr Metall Rev 41:311–322. https://doi.org/10.1080/08827508.2019.1636048
Jiang Y, Chen Y, Zi F, Hu X, Chen S, He P, Zhao L, Li X, Li J, Lin Y, Li Z (2022) Making untreated carbon effective in cleaner thiosulfate system: a new and high-efficiency method including gold adsorption and desorption. J Clean Prod 334:130185. https://doi.org/10.1016/j.jclepro.2021.130185
Jin Zhao ZW, Jiayong C (1997) Extraction of gold from thiosulfate solutions with alkyl phosphorus esters. Hydrometallurgy 46:363–372. https://doi.org/10.1016/s0304-386x(97)00031-5
Kejun L, Yen WT, Shibayama A, Miyazaki T, Fujita T (2004) Gold extraction from thiosulfate solution using trioctylmethylammonium chloride. Hydrometallurgy 73:41–53. https://doi.org/10.1016/j.hydromet.2003.07.007
Lampinen M, Laari A, Turunen I (2015) Ammoniacal thiosulfate leaching of pressure oxidized sulfide gold concentrate with low reagent consumption. Hydrometallurgy 151:1–9. https://doi.org/10.1016/j.hydromet.2014.10.014
Liu X, Jiang T, Xu B, Zhang Y, Li Q, Yang Y, He Y (2020) Thiosulphate leaching of gold in the Cu–NH3–S2O32−–H2O system: an updated thermodynamic analysis using predominance area and species distribution diagrams. Miner Eng 151:106336. https://doi.org/10.1016/j.mineng.2020.106336
Lu J, Wu X, Li Y, Cui W, Liang Y (2018) Modified silica gel surface with chelating ligand for effective mercury ions adsorption. Surf Interfaces 12:108–115. https://doi.org/10.1016/j.surfin.2018.04.005
Mahandra H, Faraji F, Ghahreman A (2021) Novel extraction process for gold recovery from thiosulfate solution using phosphonium ionic liquids. ACS Sustain Chem Eng 9:8179–8185. https://doi.org/10.1021/acssuschemeng.1c01705
Meng Q, Yan X, Li G (2021) Eco-friendly and reagent recyclable gold extraction by iodination leaching-electrodeposition recovery. J Clean Prod 323:129115. https://doi.org/10.1016/j.jclepro.2021.129115
Rao MD, Singh KK, Morrison CA, Love JB (2021) Recycling copper and gold from e-waste by a two-stage leaching and solvent extraction process. Sep Purif Technol 263:118400. https://doi.org/10.1016/j.seppur.2021.118400
Sun C-b, Zhang X-l, Kou J, Xing Y (2020) A review of gold extraction using noncyanide lixiviants: fundamentals, advancements, and challenges toward alkaline sulfur-containing leaching agents. Int J Miner Metall Mater 27:417–431. https://doi.org/10.1007/s12613-019-1955-x
Tauetsile PJ, Oraby EA, Eksteen JJ (2019) Activated carbon adsorption of gold from cyanide-starved glycine solutions containing copper. Part 1: isotherms. Sep Purif Technol 211:594–601. https://doi.org/10.1016/j.seppur.2018.09.024
Tian Y, Yin P, Qu R, Ji C, Sun Y, Xu Q, Yu Z (2010) Kinetic investigation of silica gel chemically modified by ethylenediamine bis(methylene phosphonic acid) for adsorption of Au(Iii). Prog React Kinet Mech 35:404–416. https://doi.org/10.3184/146867810x12853409374184
Wang Q, Hu X, Zi F, Yang P, Chen Y, Chen S (2019) Environmentally friendly extraction of gold from refractory concentrate using a copper–ethylenediamine–thiosulfate solution. Sep Purif Technol 214:860–872. https://doi.org/10.1016/j.jclepro.2019.01.007
Wang C, Chen S, Chen Y, Zi F, Hu X, Qin X, Zhang Y, Yang P, He Y, He P, Lin Y, Zhang G (2020) Modification of activated carbon by chemical vapour deposition through thermal decomposition of thiourea for enhanced adsorption of gold thiosulfate complex. Sep Purif Technol 241:116632. https://doi.org/10.1016/j.seppur.2020.116632
Xu B, Kong W, Li Q, Yang Y, Jiang T, Liu X (2017) A review of thiosulfate leaching of gold: focus on thiosulfate consumption and gold recovery from pregnant solution. Metals 7:222. https://doi.org/10.3390/met7060222
Xu B, Li K, Li Q, Yang Y, Liu X, Jiang T (2019) Kinetic studies of gold leaching from a gold concentrate calcine by thiosulfate with cobalt-ammonia catalysis and gold recovery by resin adsorption from its pregnant solution. Sep Purif Technol 213:368–377. https://doi.org/10.1016/j.seppur.2018.12.064
Yang Y, Gao W, Xu B, Li Q, Jiang T (2019) Study on oxygen pressure thiosulfate leaching of gold without the catalysis of copper and ammonia. Hydrometallurgy 187:71–80. https://doi.org/10.1016/j.hydromet.2019.05.006
Yu H, Zi F, Hu X, Nie Y, Xiang P, Xu J, Chi H (2015) Adsorption of the gold–thiosulfate complex ion onto cupric ferrocyanide (CuFC)-impregnated activated carbon in aqueous solutions. Hydrometallurgy 154:111–117. https://doi.org/10.1016/j.hydromet.2015.04.009
Zhang H, Dreisinger DB (2004) The recovery of gold from ammoniacal thiosulfate solutions containing copper using ion exchange resin columns. Hydrometallurgy 72:225–234. https://doi.org/10.1016/s0304-386x(03)00183-x
Zhang XM, Senanayake G (2016) A review of ammoniacal thiosulfate leaching of gold: an update useful for further research in non-cyanide gold lixiviants. Miner Process Extr Metall Rev 37:385–411. https://doi.org/10.1080/08827508.2016.1218872
Zhu Y, Liu H, Chen T, Xu B, Li P (2016) Kinetics and thermodynamics of Eu(III) adsorption onto synthetic monoclinic pyrrhotite. J Mol Liq 218:565–570. https://doi.org/10.1016/j.molliq.2016.01.100
Acknowledgements
This work was financially supported by the National Natural Science Foundation of China (51674128). The authors sincerely thank the Key Laboratory of Chemical Separation Enrichment and Application in Yunnan Province Universities for their help and support.
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
Conflict of interest
The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Supplementary Information
Below is the link to the electronic supplementary material.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Li, J., Chen, S., Chen, Y. et al. Method for improving adsorption capacity of gold(I) thiosulfate complex on mercapto-functionalized silica gel by masking copper with ethylenediamine. Braz. J. Chem. Eng. 41, 325–337 (2024). https://doi.org/10.1007/s43153-023-00326-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s43153-023-00326-x