Details about how to use the
AH-ACC-BKT-AX-WL bracket for direct-to-wall installations.
Before you begin
The following hardware is required for direct-to-wall installations:
- An indoor access point
- One AH-ACC-BKT-AX-WL bracket
- Three M3.5 screws and three
screw-in anchors, shipped with the -WL bracket
About this task
The AH-ACC-BKT-AX-WL bracket is for users who already have the -WL bracket. For new
wall installations, order either the -TB or -JB bracket.
Procedure
-
Using the -WL bracket as a
template, mark and drill mounting holes on the wall.
-
Bring the LAN cable from the wall through the bracket hole.
Align the cable before
attaching the bracket to the wall.
Note
A standard Ethernet cable can
be used if you do not mind the cable being visible. To hide the Ethernet
cable, a flat cable and a cable cap is required.
-
Attach the wall bracket to the
wall using three M3.5 screws and three screw-in anchors.
-
Align the access point red dot
against the three red dots on the -WL bracket.
-
Press and rotate the access
point clockwise about one-sixth turn until it locks into place on the
bracket.
-
Attach the Cat5e RJ45 cable to
the ETH0 port on AP305C/CX or the Cat6 RJ45 cable to the ETH0 or ETH1
port on all other indoor access points.
-
Place the cable cover over the Ethernet cable.
Note
The cable cover will work only if you use a flat cable adapter.
