What I am looking for is the option to turn off the dimming functionality so it can only operate on/off. Is there any way in your driver to do this? Would it be possible to add this as an option in the settings?
Added in this version a preference to change to a profile without level capability
βββββββββββββββββββββββββββββββββββββββββββββββββββ
Name Zigbee Switch Power Mc
Version 2023-12-19T12:31:10.555844429
βββββββββββββββββββββββββββββββββββββββββββββββββββ
- name: "useAsSwitchOnly"
title: "Use device as Switch Only"
required: false
preferenceType: boolean
definition:
default: false
You need uninstall device
Install this driver version in your hub and reinstall device to configure it
βββββββββββββββββββββββββββββββββββββββββββββββββββ
Name Zigbee Multi Switch and Child Mc
Version 2023-12-26T14:58:14.106689144
βββββββββββββββββββββββββββββββββββββββββββββββββββ
- id: "TS0003/_TZ3000_66fekqhh"
deviceLabel: Two Switch & One Plug
manufacturer: _TZ3000_66fekqhh
model: TS0003
deviceProfileName: three-outlet
Added to this driver version.
The better option is pair device with this driver version installed in your hub, do not perform a driver version from zigbee thing
βββββββββββββββββββββββββββββββββββββββββββββββββββ
Name Zigbee Light Multifunction Mc
Version 2023-12-26T15:05:30.181616607
βββββββββββββββββββββββββββββββββββββββββββββββββββ
- id: "_TZ3210_4zinq6io/TS0501B"
deviceLabel: Dimmer TS0501B
manufacturer: _TZ3210_4zinq6io
model: TS0501B
deviceProfileName: switch-level
However, Iβd like to know for sure, or whether Iβm missing something, if thereβs a way of detecting if a light has been switched on in the app by pressing a tileβs power button and differentiating that from the device being switched on by an automation.
I realise this isnβt strictly a question around this specific driver, but it might have a βworkaroundβ perhaps? Alsoβ¦
I know the physical light switch sends a βbutton pushedβ signal out of the Fibaro so I can see if itβs been physically switched.
I have set the S1/2 scenes to pressed 1 time, but Iβve tried held and released and a few others. This doesnβt seem to work and I can only get βpressedβ to be sent for both on and off. Is there any way to send different states for on/off from the physical switch?
These devices were added at the request of other users and seem to work well for them.
Your driver may not be installed correctly, sometimes it seems wrong. Try uninstalling it and installing it again.
For devices to be configured correctly they must be paired directly with the driver, a driver change does not always work.
Tuya devices have the standard attribute for power divisors and multipliers and therefore if your device indicates 100 times more energy than the real one, you must enter a divisor by 100 in the βCustom Simple Metering Dividerβ preference settings.