|
|
|
Switch Module IP address, subnet mask, and default gateway |
0.0.0.0 |
Chapter 4, “Assign the Switch Module IP Address and Default Gateway” |
Domain name |
None |
Passwords |
None defined |
Chapter 6, “Administer the Switch Module” |
TACACS+ |
Disabled |
RADIUS |
Disabled |
System name and prompt |
Switch |
NTP |
Enabled |
DNS |
Enabled |
MODBUS TCP |
Disabled |
Chapter 16, “MODBUS TCP Configuration” |
802.1x |
Disabled |
See “Configuring IEEE 802.1x Port-Based Authentication” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/sw8021x.html) |
|
DHCP client |
Enabled |
Chapter 4, “Assign the Switch Module IP Address and Default Gateway” See “Configuring DHCP Features and IP Source Guard” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swdhcp82.html) |
DHCP server |
Enabled if the device acting as a DHCP server is configured and is enabled |
DHCP relay agent |
Enabled (if the device is acting as a DHCP relay agent and is configured and enabled) |
|
Port type |
Gigabit Ethernet: NNI, Fast Ethernet ports: NNI |
Chapter 8, “Interface Configuration” |
Operating mode |
Layer 2 (switchport) |
Port enable state |
Enabled for NNIs; disabled for UNIs and ENIs |
Interface speed and duplex mode |
Autonegotiate |
Auto-MDIX |
Enabled |
Flow control |
Off |
Command Macros |
None configured |
Chapter 10, “Smartports Macros Configuration” |
|
Default VLAN |
VLAN 1 |
Chapter 11, “VLAN Configuration” |
VLAN interface mode |
Access |
VLAN type |
UNI isolated |
Private VLANs |
None configured |
Chapter 12, “Private VLAN Configuration” |
Dynamic ARP inspection |
Disabled on all VLANs |
See “Configuring Dynamic ARP Inspection” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swdynarp.html) |
Tunneling |
802.1Q tunneling |
Disabled |
Chapter 13, “IEEE 802.1Q and Layer 2 Protocol Tunneling Configuration” |
Layer 2 protocol tunneling |
Disabled |
|
STP |
Rapid PVST+ enabled on NNIs in VLAN 1 |
See “Configuring STP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swstp.html) |
MSTP |
Disabled (not supported on UNIs, can be configured on ENIs) |
See “Configuring MSTP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swmstp.html) |
Optional spanning-tree features |
Disabled (not supported on UNIs, but it can be configured on ENIs) |
See “Configuring Optional Spanning-Tree Features” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swstpopt.html) |
Resilient Ethernet Protocol |
Not configured |
See “Configuring Resilient Ethernet Protocol” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swrep.html) |
Flex Links |
Not configured |
See “Configuring Flex Links and the MAC Address-Table Move Update Feature” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swflink.html) |
|
Disabled |
|
IP source guard |
Disabled |
See “Configuring DHCP Features and IP Source Guard” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swdhcp82.html) |
|
IGMP snooping |
Enabled |
See “Configuring IGMP Snooping and MVR” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swigmp.html) |
IGMP filters |
None applied |
IGMP querier |
Disabled |
MVR |
Disabled |
IGMP throttling |
Deny |
Port-based Traffic Control
|
Broadcast, multicast, and unicast storm control |
Disabled |
See “Configuring Port-Based Traffic Control” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swtrafc.html) |
Protected ports |
None defined |
Unicast and multicast traffic flooding |
Not blocked |
Secure ports |
None configured |
CDP |
Enabled on NNIs, disabled on ENIs, not supported on UNIs |
See “Configuring CDP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swcdp.html) |
LLDP |
Disabled (not supported on UNIs) |
See “Configuring LLDP and LLDP-MED” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swlldp.html) |
UDLD |
Disabled |
See “Configuring UDLD” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swudld.html) |
SPAN and RSPAN |
Disabled |
See “Configuring SPAN and RSPAN” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swspan.html) |
RMON |
Disabled |
See “Configuring RMON” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swrmon.html) |
Syslog messages |
Enabled; displayed on the console. |
See “Configuring System Message Logging” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swlog.html) |
SNMP |
Enabled; Version 1 |
See “Configuring SNMP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swsnmp.html) |
ACLs |
None configured |
See “Configuring Network Security with ACLs” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swacl.html) |
QoS |
Not configured |
Chapter 14, “Quality of Service Configuration” |
EtherChannels |
PortChannel 48 |
Chapter 9, “EtherChannel Configuration Between the Switch Module and the Host Router” |
|
IP routing and routing protocols |
Disabled |
See “Configuring IP Unicast Routing” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swiprout.html) |
Multi-VRF-CE |
Disabled |
HSRP groups (requires IP services image) |
None configured |
See “Configuring HSRP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swhsrp.html) |
Cisco IOS IP SLAs |
Not configured |
See “Configuring Cisco IOS IP SLAs Operations” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swipsla.html) |
Enhanced object tracking |
No tracked objects or list configured |
See “Configuring Enhanced Object Tracking” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/sweot.html) |
IP multicast routing (requires IP services image) |
Disabled on all interfaces |
See “Configuring IP Multicast Routing” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swmcast.html) |
MSDP (requires IP services image) |
Disabled |
See “Configuring MSDP” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swmsdp.html) |
|
CFM |
Disabled globally, enabled per interface |
See “Configuring Ethernet OAM, CFM, and E-LMI” ( http://www.cisco.com/en/US/docs/switches/connectedgrid/cgs2520/software/release/12_2_53_ex/configuration/guide/swoam.html) |
E-LMI |
Disabled globally |
Ethernet OAM protocol (802.3ah) |
Disabled on all interfaces |